High quality electric float with with 10mt of PVC cable. Can be uses on low voltage or 240 volt systems. This float with comes with a piggy back plug for easy installation. It can also be used as an open or closed circuit switch. This switch is widely used in tank top up situations.
The float switch provides versatile multifunction control for pump protection, pump control, 3-way valve control and tank water level management. Capable of loads up to 16 amps, it provides direct control of pumps up to 1.5 horsepower at 115V or 2 horsepower at 230V and is also suitable for low voltage (12-24VAC/VDC) circuits, valves and controls.
The multifunction float switch and its 30 foot, 16 AWG cord are lead-free and mercury-free and have been tested and certified ROHS compliant for your safety.
Operating as a single-pole, double throw (SPDT) switch, it can be used to protect pumps from running dry, or to add water from an outside source such as a well when the water level reaches a minimum level, or it can be used to activate a pump or valve to drain the tank when the water level reaches a maximum (overflow) level, or it can be used to control a 3-way valve for a backup water supply.
The Normally Open (NO) and Normally Closed (NC) designations refer to the electrical contact state when the float is in the hanging position. The switch changes its state when it reaches approximately 45 degrees up or down.
The Float Switch will Operate in Three Modes:
(1) Auto-fill mode: The switch contacts will be closed when the float is in the hanging position. This is often called a “pump up” or “normally closed” application.
In this application, the float switch is used to activate a pump, relay or valve for the purpose of adding water to the tank from an auxiliary source. This application is used to assure water availability while keeping the tank empty enough to capture rainwater when it becomes available. The float switch cord is secured at the desired low water level threshold.
In auto-fill mode, the Black wire is connected to the AC neutral supply and the Blue wire is connected to the pump, relay or valve’s neutral input. The Brown wire is unused.
(2) Pump protection and auto-drain mode: The switch contacts will open when the float is in the hanging position. This is often called a “pump down” or “normally open” application.
Pump protection application: In this application, the float switch is used to disable power to the pump when the water level reaches a minimum threshold for the purpose of protecting the pump and/or to prevent extraction of the undesirable layer of water at the bottom of the tank.
Auto-drain application: In this application, the float switch is used to activate a continuous-duty relay or valve for the purpose of draining a tank down to a desired water level. This application can be used to drain an auxiliary “first flush” tank which is installed in-line prior to the main storage tank. The float switch cord is secured at the desired low water level threshold.
In both of these applications, the Black wire is connected to the AC neutral supply and the Brown wire is connected to the pump, relay or valve neutral input. The Blue wire is unused.